2" leveling kit
#7
For anyone else reading this that has the same question as the OP, don't make a new thread, keys are dumb, tightening the bolt does the exact same thing, but it's free, easier, and faster.
#8
I cranked my t bars up about two months ago got an alignment and she drives and preforms perfect. She looks good too. Around 6 to 8 full turns on the bolt gave me just under 2" in less than half an hour. Its free practically, just the cost of an alignment. I agree that keys are a total marketing scam. Anyone with this same question shouldn't worry about CV joint angles as they are fine. If anything a key will waste your money.
#9
#10
In theory yes. However depending on how new or old the bars are and how "springy" or broken in they are it will vary. Its honestly a really easy process; Jack the front end up to relieve stress and pressure on bars, crank the bolt say one full turn, put her down, and measure. I took my truck for a spin around the block trying to hit some of the bumps to "break it in" and re measured after the test run and adjusted accordingly. Experiment and start off slowly until you reach desired height. Good luck!
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: 2 in leveling kit or suspension lift kit. N.C
rangerred
OLD - Suspension, Tires, & Wheels
4
10-18-2012 12:02 PM
Want to Buy: 93 - 97 leveling 2wd leveling kit
tdaws93
OLD - Suspension, Tires, & Wheels
4
06-09-2010 04:20 PM