1" & 3" Body LiftsGeneral discussion of body lifts for the Ford Ranger.
Welcome to Ford Ranger Forums - The Ultimate Ford Ranger Resource
Welcome to Ford Ranger Forums - The Ultimate Ford Ranger Resource
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
I took my 3" body lift off last summer, and have been thinking about a 1" body lift lately for a slightly better look with the 32s I plan on getting this summer. Would Cutting down the
3" blocks to 1" be a bad idea? I have the ability to turn them down on a lathe so I can get them all accurately 1" instead of just bandsawing them. Does this affect the structural integrity of the blocks? I could go and buy 1" blocks, but this is cheaper and easier for me to do.
Yes, because you can sell the 3in body lift to another member on here, and go out and buy the supplies to do the 1" body lift. PM Shane, he was 1" body lift before he did any "lifting" mods.
Did you not see the 1" BL thread at the top of this very section you posted in?
PA makes 1x3" lift blocks and a few members are running a 1" BL. They're only $1.99 each, it's worth it to just buy new blocks. Only requires the blocks and bolts w/ washers and that's it. All the info can be found in that thread.
Modifying 3" Blocks for 1" Lift?
