Anyone running a efan & pulley?
#1
Anyone running a efan & pulley? +Pulley Q
Is anyone running an efan, and underdrive pulley? If so how is it working out and what kind of gains, loss' or noticeble differences are there. I have the 3.SLOW and am trying to get a little kick out of it since I'm running 32"s now and will run 35"s sometime during the summer.
Thanks for the input!
Thinking about getting a Bama Xcal over summer too if anyone has any input with all three of those mods together........
Thanks for the input!
Thinking about getting a Bama Xcal over summer too if anyone has any input with all three of those mods together........
Last edited by pushdeck; 02-20-2007 at 12:18 PM.
#2
I have a UD pulley and an efan. After these mods I smoked D in the quarter. You should have seen him cry! Beat down by a 3.0! Okay, that's not entirely true - Marines don't cry.
Seriously, the pulley gives a noticeable increase 8-10HP. I haven't had any charging issues. I just have the single crank pulley. I didn't really notice any power increase with the efan, but I did gain some MPG. The fan runs off of a thermostat so it doesn't run continously and I have an override switch wired in so I can turn it off on long highway drives. BTW, the tuner rocks.
Seriously, the pulley gives a noticeable increase 8-10HP. I haven't had any charging issues. I just have the single crank pulley. I didn't really notice any power increase with the efan, but I did gain some MPG. The fan runs off of a thermostat so it doesn't run continously and I have an override switch wired in so I can turn it off on long highway drives. BTW, the tuner rocks.
#8
I was wondering what the advantages and disadvantages of the pulley kits (I think its 3 pulleys, underdrive, alt, and pump?) vs. just the underdrive pulley? Gas milage, torque, hp ect. I don't know which one I want.
Found the efan I want, just want to order both from same place and save a lil mabye.... so just need to figure out what I want in the pulley area....
Thanks
Found the efan I want, just want to order both from same place and save a lil mabye.... so just need to figure out what I want in the pulley area....
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Goodysgotacuda
OLD - Engine & Drivetrain
6
05-17-2009 12:58 AM
sambob117
Audio & Video Tech
3
08-27-2008 07:02 AM
jrpro130
General Technical & Electrical
69
05-23-2008 05:19 PM