P0176 code?
#1
P0176 code?
Own a 99 Ranger with a 3.0.The truck runs for about 4 minutes and dies.Won't restart.The truck then shoots a P0176 code ever hear of this? Tried it 30 minutes later and it did the same thing ran for 4 minutes and died.Does anybody have any ideas or run across this before? Please help.
#3
This from another thread :
01-5-2
DRIVEABILITY - ROUGH IDLE - DIAGNOSTIC TROUBLE CODES (DTCS) P0500, P0501, P0503, P1721, P0176, OR P1000 STORED IN MEMORY - WATER INTRUSION AT CONNECTOR C309 OR C340 UNDER DRIVER'S SEAT - VEHICLES PRODUCED BEFORE 1/2/2001
By this I would crawl under the truck in the area of the driver's seat and look up , inboard of the frame rail. There will be a square plug with a ~10mm bolt in the center.Remove the bolt and unplug the connector.Clean the terminals and coat with dielectric grease.
Only took me 1 minute using the SEARCH button.
01-5-2
DRIVEABILITY - ROUGH IDLE - DIAGNOSTIC TROUBLE CODES (DTCS) P0500, P0501, P0503, P1721, P0176, OR P1000 STORED IN MEMORY - WATER INTRUSION AT CONNECTOR C309 OR C340 UNDER DRIVER'S SEAT - VEHICLES PRODUCED BEFORE 1/2/2001
By this I would crawl under the truck in the area of the driver's seat and look up , inboard of the frame rail. There will be a square plug with a ~10mm bolt in the center.Remove the bolt and unplug the connector.Clean the terminals and coat with dielectric grease.
Only took me 1 minute using the SEARCH button.
#4
http://www.aa1car.com/
go to this site & see if this helps. Save to favs. for future.OTRtech is probably correct. Go to this site & read about this code & you will see. Good luck.
go to this site & see if this helps. Save to favs. for future.OTRtech is probably correct. Go to this site & read about this code & you will see. Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
n3elz
General Technical & Electrical
7
01-21-2005 11:10 AM
n3elz
General Technical & Electrical
3
10-22-2004 06:06 PM