2.9L & 3.0L V6 Tech General discussion of 2.9L and 3.0L V6 Ford Ranger engines.

Ignition Coil Malfunction?

Thread Tools
 
Search this Thread
 
  #1  
Old 02-17-2010
horne218's Avatar
Member
Thread Starter
Join Date: Feb 2010
Location: Winnsboro
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Ignition Coil Malfunction?

My check engine light is on, the code that comes up is po352 (ignition coil B primary/secondary malfunction). I replace the plugs and wires, this helped a little (the plugs were pretty worn) ,but the CEL is still on and it is running rough. Next I replaced the ignition coil, still the CEL is on and it is running rough. I pulled the fuel pump fuse and pulled each spark plug out and checked for a spark when it was cranked. All but coil number 3 had a spark, and I check the wire and plug on another coil their both good.
So, I put a new coil pack in and coil number 3 was no power. Is it possible that I got a bad coil or is there something between the coil and PCM I need to check?
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Aiden123
2.9L & 3.0L V6 Tech
13
08-28-2009 08:28 PM
monkeysteeler12
General Technical & Electrical
5
06-14-2009 12:05 AM
b3kbruiser
General Technical & Electrical
6
03-30-2009 11:32 AM
BlackStallion
General Technical & Electrical
14
09-24-2008 08:29 AM
beddy60
General Technical & Electrical
5
03-19-2007 11:25 AM



Quick Reply: Ignition Coil Malfunction?



All times are GMT -6. The time now is 02:16 PM.