2.9L & 3.0L V6 Tech General discussion of 2.9L and 3.0L V6 Ford Ranger engines.

3.0L rattle?

Thread Tools
 
Search this Thread
 
  #1  
Old 04-21-2012
Jack_RANGER's Avatar
Member
Thread Starter
Join Date: Feb 2012
Location: Guelph ont
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
3.0L rattle?

Hey all ! Jack here i have a 2004 ford ranger Edge with the 3L in it and i love it! But when i drive UNDER LOAD at around 2500-3500 rpm i hear a wicked rattle. sounds to me like the rockers are loose, but it will only do it under load. It will only last for a few seconds. try to get it to do it at idle but it will not do it. Any ideas ? It was burning oil but i switched it to 10w-30 Synthetic and it only burns after around 4-5k on that only change. will NOT burn a drop of oil till then. I was thinking of taking the valve covers off and see if i can adjust the rocker but i want to get a few opinion on it first, and i have a funny feeling your cant adjust em.
Cheers Jack!
 
  #2  
Old 04-21-2012
Froggmann's Avatar
Member
iTrader: (2)
Join Date: Mar 2011
Location: Bloomington, MN
Posts: 209
Likes: 0
Received 1 Like on 1 Post
Sounds like spark knock/pinging. If the truck is flex fuel, try running a couple tanks of E-85 through it.
 
  #3  
Old 04-21-2012
Jack_RANGER's Avatar
Member
Thread Starter
Join Date: Feb 2012
Location: Guelph ont
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
Truck does not have flex fuel. But it could be the injectors...
 
  #4  
Old 04-21-2012
Froggmann's Avatar
Member
iTrader: (2)
Join Date: Mar 2011
Location: Bloomington, MN
Posts: 209
Likes: 0
Received 1 Like on 1 Post
I doubt the injectors are bad. I was suggesting using E-85 because it's a great fuel system cleaner and cleans the combustion chambers well.

Seafoam the truck and see if that improves the pinging problem.
 
  #5  
Old 04-23-2012
iplayloudly's Avatar
Member
Join Date: May 2007
Location: Cordova, TN
Posts: 183
Likes: 0
Received 0 Likes on 0 Posts
i have a similar issue thats been going on as long as I've owned the truck (since Jan last year). Mine is also an '04 edge. Drove me crazy for the first few months, and then I just gave up and quit worrying about it. I'm usually pretty light on the throttle anyway so its rare I even hear it.

Mine doesn't burn any oil though. It also doesn't make the noise when cruising around 3000 rpm, only when accelerating quickly.
 
  #6  
Old 04-23-2012
Jack_RANGER's Avatar
Member
Thread Starter
Join Date: Feb 2012
Location: Guelph ont
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
Ok so i figured it out! so after reading through different threads and pin pointing the problem i ended up fulling my tank with 50/50 gas aka reg/prem and pinging almost went away! so i went and got some seaform and ran it through the good old ranger and its GONE ! have not heard it yet and I've tried everything to get it to do it again and still no pinging. so if you got the problem i would start by putting a higher grade fuel in to the truck!
 
  #7  
Old 04-23-2012
paganwars's Avatar
Member
Join Date: May 2010
Location: Madison
Posts: 347
Likes: 0
Received 0 Likes on 0 Posts
Higher grade fuel is just a temporary fix to the problem, and shouldnt be used exclusively. Filling it up with premium is just a way to diagnose which problem it is, so if it goes away, that tells you it is in fact spark knock and not something else. These trucks are made to run on regular, so when you go back to that fuel, and the rattle comes back, then the issue is still there. Seafoam will cure it, other things like changing spark plugs, wires coil pack, and pcv valve will also help. You can clean your maf sensor, iac, and throtle body as well. My 4.0 does this from time to time, i just dont let it bog down when going up hills and its not a problem. Just curious, did you run the seafoam through the fuel or into the brake booster??
 
  #8  
Old 04-23-2012
iplayloudly's Avatar
Member
Join Date: May 2007
Location: Cordova, TN
Posts: 183
Likes: 0
Received 0 Likes on 0 Posts
oh ok, mine is not a pinging type noise, more of a vibration/rattle. As if something is hitting its resonant frequency and vibrating quickly.
 
  #9  
Old 04-23-2012
Jack_RANGER's Avatar
Member
Thread Starter
Join Date: Feb 2012
Location: Guelph ont
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
ok so i ran Seafoam through the intake. It was a like a spray can. hold the RPMs up at 1100 and spray it for 2-3 mins and it smokes cleaning all the stuff out of it. and i must say it runs mint now. right after i put the premium gas in it was still there but not as much, after i did seafoam haven't heard it yet. i plan on doing plugs wire and core some time in the near future.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Tight Ranger
Interior Semi-Tech
3
06-19-2005 11:17 AM
GrafixGuy
DOHC - 2.3L Duratec / Mazda L Engines
8
03-09-2005 12:55 PM
Zero
General Technical & Electrical
12
12-18-2004 02:48 AM
V8 Level II
Drivetrain Tech
38
11-15-2004 10:36 AM
EtniesRIT
4.0L OHV & SOHC V6 Tech
0
06-01-2004 08:04 PM



Quick Reply: 3.0L rattle?



All times are GMT -6. The time now is 01:54 AM.