3.0 to 4.0 swap
#1
3.0 to 4.0 swap
ok lets just say i got a 4.0 out of a 2000 ranger ahhh or explorer with transmission and everything wiring harness all the goods... how long do you think it would take to install this?
because dads going outta town for a week or two and im thinking about tackling this while hes gone lol maybe he wont notice if i get it done before he gets back...
ive already found a donor but would it matter if i used tranny and 4.0 out of a newer model ranger because im looking for something with less mileage..
well lets hear the opinions and ftw i dont want a v8... i just want that little extra power and the tranny strenth of the 5R55E for highway driving because my 3.0 and 4r44e cant handle long term driving on the interstate.. with 4.56 gears and 33's
ok opinions please
because dads going outta town for a week or two and im thinking about tackling this while hes gone lol maybe he wont notice if i get it done before he gets back...
ive already found a donor but would it matter if i used tranny and 4.0 out of a newer model ranger because im looking for something with less mileage..
well lets hear the opinions and ftw i dont want a v8... i just want that little extra power and the tranny strenth of the 5R55E for highway driving because my 3.0 and 4r44e cant handle long term driving on the interstate.. with 4.56 gears and 33's
ok opinions please
#3
ya the wiring harness and pcm all come with the donor but could i use a newer model exporer or ranger? or would the pcm not work im just trying to find one with decent miles on it like 50-100k will be alright and ill just replace everything before i put the engine in.. but everything is just plug n play besides that right?
#4
#6
alright i appreciate the help i think im gonna just wait a while till i find a good deal with low mileage till then ima just start getting parts like motor mounts tranny mounts under drive pulleys belts.. ect.. whenever i get the engine ima just clean it up and rebuild it so itl be in tip top shap when i drop it in
#7
i donno about the sohc 4.0 but the motor mounts for the ohv 4.0 are almost the same as the 3.0 mounts. the drivers side is different because of the factory spacer its bolted to. if you cut that spacer apart you can unbolt it from the mount and bolt the mount directly to the frame in the same spot. at least for the 2wd ones.
Thread
Thread Starter
Forum
Replies
Last Post
2001fordranger
Drivetrain Tech
6
03-05-2011 07:06 PM