Starter Relay
#3
what he wants to know is his brothers 94 2wd ranger is not starting. he bought a new sol. because he broke the other one. and now the truck does not start. i cant help him out because he lives a distance from me. i think that the sol is wired wrong. if anyone can send me a wiring diagram of it that would be great. thanx
#4
Quick and dirty, since no one else is helping....
Bat+ to big solenoid post (put all the "other" terminals on this post too)
the remaining big solenoid post should ONLY have the cable that goes to the starter connected to it.
The small studs get one terminal each, not sure if polarity even matters. If it is set up as described above and still won't work, swap the two little terminals around. Now that I think about it, that coil may have a snubber, so polarity MAY matter.
Bat+ to big solenoid post (put all the "other" terminals on this post too)
the remaining big solenoid post should ONLY have the cable that goes to the starter connected to it.
The small studs get one terminal each, not sure if polarity even matters. If it is set up as described above and still won't work, swap the two little terminals around. Now that I think about it, that coil may have a snubber, so polarity MAY matter.
Thread
Thread Starter
Forum
Replies
Last Post
rngprerunner
General Ford Ranger Discussion
17
10-13-2022 09:41 AM
cheese_man
General Technical & Electrical
1
07-18-2014 03:25 AM
rangerrunner11
General Ford Ranger Discussion
3
08-07-2012 08:56 PM
jtfoxman
General Technical & Electrical
12
07-21-2010 11:34 PM