Vacuum Lines
#1
Vacuum Lines
New to the forum here. Long time ranger owner. My current truck is a 2001 Ford Ranger XLT 4.0 4x2. I had the truck about 20 years I recently hit over 200K when I decide to do an engine swap. I currently have installed the engine and I have vacuum line I do NOT know where iT goes. I have attached a picture of a diagram showing the end of the hose I trying to connect. Any help would be apricated. Thanks
#2
I think the line you circled gets extended to the vacuum reservoir associated with the "Max AC" blend door closer.
Mine is sphere shaped, in the engine bay on the right inner fender ahead of the axle line.
The vacuum line is reduced to hard, smaller diameter vacuum line 2 feet before it reaches the reservoir.
Mine is sphere shaped, in the engine bay on the right inner fender ahead of the axle line.
The vacuum line is reduced to hard, smaller diameter vacuum line 2 feet before it reaches the reservoir.
#3
#4
That loose VacHose may be control line to junk plastic HeaterControlValve,
factory mounted\hidden underneath Alternater in 5/8"CoolantLine running from WaterPump to HeaterCore.
Click here for more info on the 2Way HeaterControlValve.
factory mounted\hidden underneath Alternater in 5/8"CoolantLine running from WaterPump to HeaterCore.
Click here for more info on the 2Way HeaterControlValve.
#5
The following users liked this post:
DILLARD000 (07-01-2022)
#6
The following users liked this post:
DILLARD000 (07-05-2022)
Thread
Thread Starter
Forum
Replies
Last Post
mjharris89
4.0L OHV & SOHC V6 Tech
2
08-06-2017 11:16 PM