crankshaft seal
#1
#3
#4
I'll be doing one in the next couple of days and I'll let you know. It looks pretty straight forward and I don't see any need to touch the pan. In reading up on this in the manual it states to replace the Crank bolt with a new one? Any opinions would be appreciated. Are they prone to fail if used again? I built engines with used head bolts that were suppose to be replaced with new ones with no problems, is this the same.
01 didn't intend to hyjack you thread my apologies.
01 didn't intend to hyjack you thread my apologies.
#5
no man its cool its nice to be in the same boat let me know how yours goes i just need torque specs i think just popin the nut off pry the old one out and zippin the nut back on was pretty stright forward but ive never done this before i wanna be 100% possitive its my daily driver so i knida need it lol thanks
Thread
Thread Starter
Forum
Replies
Last Post
1996Ranger4x4SuperCabSTX
General Ford Ranger Discussion
9
12-10-2019 03:07 PM