Bama Tuner trans pressure settings
#1
Bama Tuner trans pressure settings
Where have you guys set yours at? +5%, +10%, ????
I have mine at +5 right now and I think it could use more but I am wondering if +10% would be too much of a jump (too harsh on the drivetrain). Now bear in mind that my trans. has been set up to shift harder than the average Bama tune at both part throttle and full throttle because I had Doug to revise my tune after getting my tuner because I wasn't satisfied with the standard Bama tune shifts (part and full throttle).
So where are you guys at?
BTW, I have my shifts set to occur right at 6000 rpm at WOT.
I have mine at +5 right now and I think it could use more but I am wondering if +10% would be too much of a jump (too harsh on the drivetrain). Now bear in mind that my trans. has been set up to shift harder than the average Bama tune at both part throttle and full throttle because I had Doug to revise my tune after getting my tuner because I wasn't satisfied with the standard Bama tune shifts (part and full throttle).
So where are you guys at?
BTW, I have my shifts set to occur right at 6000 rpm at WOT.
#2
I have some tunes by Fredness (Rogue Performance) and I had the same problem -- his "firm" was still mushy. I have mine up around 5 to 8 percent I believe for shifts at higher throttle setting.
I'm using ExtremeTune though and not an XCAL2 so it's hard to know if the units are the same or not -- still, I did crank it up.
I'm using ExtremeTune though and not an XCAL2 so it's hard to know if the units are the same or not -- still, I did crank it up.
#3
#4
#7
#11
Originally Posted by Big04Ranger
my bama is set firmer then most on my tunes.. then i also have a mechanical "shift" kit installed in the valve body.. i like it alot
i like my shifts real firm......
#12
Originally Posted by lifted97ranger
i need to come up and have you help me put in a shift kit.......well along with all the other 100 parts i need your help installing
i like my shifts real firm......
i like my shifts real firm......
lol, the shift kit aint bad to install.. it was just a lil tedious as the instructions sucked
#13
#15
WOW, you got me there, I thought they only installed them on the Explorers with the SOHC engine & then the Rangers when they came out with the same engine. I guess I lost touch with Rangers when I sold my 94 & bought my F-150. I learn something new everyday...see...the old saying you can't teach old dogs new tricks doesn't apply to me even though I'll probably forget it by tomorrow :-)
Rick
Rick
#16
#17
Thread
Thread Starter
Forum
Replies
Last Post
mhue
General Technical & Electrical
3
02-17-2015 11:04 AM