swapping over mustang parts? 4.0
#1
swapping over mustang parts? 4.0
would the heads/cams/intake manifolds and throttle body from a 4.0 bolt up to the ranger block and run correctly?
also on my truck-2007, the Mass air sensor is molded into the intake tube it looks like, and the sensor slides in the slot in the tube. would there be any problems swapping a whole assembly from a mustang(if it uses a seperate housing) so that building a new intake tube assembly would be easier?
i think it would be cheaper to go this route than buy supersix motorsports heads and such. and i am sure a stock mustang cam would have a bit more aggressive design to it than a factory ranger set.
can anyone verify this?
would the fuel system and computer need any major adjustments? other than a tune for increased performance?
also on my truck-2007, the Mass air sensor is molded into the intake tube it looks like, and the sensor slides in the slot in the tube. would there be any problems swapping a whole assembly from a mustang(if it uses a seperate housing) so that building a new intake tube assembly would be easier?
i think it would be cheaper to go this route than buy supersix motorsports heads and such. and i am sure a stock mustang cam would have a bit more aggressive design to it than a factory ranger set.
can anyone verify this?
would the fuel system and computer need any major adjustments? other than a tune for increased performance?
#2
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: Mustang disc brake parts
Police Interceptor
OLD - Engine & Drivetrain
0
02-27-2011 10:31 PM
For Sale: Mustang GT Disc Brake Swap Parts (MA)
99offroadrngr
OLD - Engine & Drivetrain
11
01-26-2011 04:39 PM
swickwake
Miscellaneous Items
0
05-31-2010 01:09 AM
93rangerXLT4x4
Suspension Tech
1
08-12-2009 10:01 PM
strictlystangs2
SOHC - 2.3L & 2.5L Lima Engines
7
11-21-2007 09:54 PM