5.0 swap spring selection
#1
5.0 swap spring selection
well i have read alot of articles on this swap and I have most of it down ... I have one question that I have not found the answer to .. my truck is droped with a beltech 4/4 kit.. with the 4.0 in the truck the front end sits about 1 inch lower than the back .. so im thinking that when i put the 5.0 in it will sit even lower .. so I would like to know if anyone has been in this situation as I would like to level out the truck .. i would like a slightly stiffer spring in the front to help keep the front end from becoming a plow.. the truck is a 91 2wd short box
Thread
Thread Starter
Forum
Replies
Last Post
Cody_288
Forced Induction & N20 Tech
24
12-26-2010 01:57 AM