what is every one using for p/s
#1
what is every one using for p/s
im doing a 1994 ranger with a 302 and i want to make the p/s work i found a thing that has part numbers but it does not come back. this is where i was getting the numbers from.
all i have is the box on the truck so i need every thing.
http://www.therangerstation.com/tech...tructions.html
all i have is the box on the truck so i need every thing.
http://www.therangerstation.com/tech...tructions.html
#2
the P/S pump from most 80s ford cars will work fine. you should find a reservoir from a ford tompo / topaz 4 cyl should be used because the return line will enter from the back not the bottom as on most others. if the line comes in from the bottom it will hit the steering box. also the best way to find the proper bracket for the pump is to know what the timming cover / water pump and alt. is from. if it is from a after market company than i would consider getting the whole new setup from a 85 - 91 crown vic this would be a 2 belt set up. 1 belt for the ALT. and P/S and 1 belt for AC if equipted. the water pump is very short shaft so it will fit in a confined space. i would also use the single wire harness for the Alt.
Thread
Thread Starter
Forum
Replies
Last Post
Yellow_edge_4x4
Exterior Semi-Tech
27
01-28-2009 04:02 AM
rangerxlt4x4
General Ford Ranger Discussion
26
12-31-2007 05:17 PM
Fx4wannabe01
General Technical & Electrical
7
04-30-2007 06:56 PM