Amp power wire question
#2
Just drill a hole and then use a rubber grommet, that's what I did. There's two bolts that secure the fuse box under the hood, unbolt them and move it out of the way. When you move it you'll see there's plenty of open space to add a hole, check that there's no wires on the opposite side and then just drill. I used a step drill bit and it drills right through very easily.
The following users liked this post:
AngryPossum (11-03-2021)
#3
#5
The following users liked this post:
AngryPossum (11-03-2021)
Thread
Thread Starter
Forum
Replies
Last Post
SouthernMudSlinger
General Technical & Electrical
9
11-25-2006 07:31 AM