where to put bass control knob
#1
Join Date: Aug 2008
Location: Fresno, CA
Posts: 1,584
Likes: 0
Received 0 Likes
on
0 Posts
#2
#3
I'm thinking your 2002 would be a similar set up, interior wise, to my 2001. It also depends on your amp make and model too....I'm running a Rockford Fosgate amp. I popped off the cupholder on the floor/transmission tunnel and installed it there. I suppose it would depend as different brand amps might have a different size control ****. I couldnt get mine to fit where Korey referenced. I had to drill a small hole for the mounting bracket to fit and one for the cable and then I ran it under the carpet back to the box. You have to get a little creative. I know I sat in the truck for about 10 minutes to come up with ideas where to put it lol This was the best picture I could find. Hope this helps!
#5
Join Date: Aug 2008
Location: Fresno, CA
Posts: 1,584
Likes: 0
Received 0 Likes
on
0 Posts
#7
#8
#9
#11
that's exactly where i had mine mounted in my Ranger. now it's taken apart and mounted nicely in the radio bezel in my f150.
#12
Scroll down part way through the first post:
https://www.ranger-forums.com/forum2...ight=deadening
That is about as clean as it gets ^.
https://www.ranger-forums.com/forum2...ight=deadening
That is about as clean as it gets ^.
#13
Join Date: Aug 2008
Location: Fresno, CA
Posts: 1,584
Likes: 0
Received 0 Likes
on
0 Posts
well got the system installed yesterday here are some pics of the deck and the bass control **** and one pick of where the amp and sub are mounted and i also have the ipod connector running to my glove box to safely hide my ipod
gotta take it back tomorrow though the messed something up and now my lights on my light bar dont work but they said to just bring it back and they would fix it no problem
gotta take it back tomorrow though the messed something up and now my lights on my light bar dont work but they said to just bring it back and they would fix it no problem
#14
I built mine in place of the cigarette lighter since it didnt work anyway. People always freaked out when they found out that was a **** and it controlled the sub.
I just got a washer painted it black and stuck it in the hole, then I made a plate out of some very thin sheet metal as a place for the switch to mount. I made the sheet metal so that it mounted to one of the screws that held the 4wd switch on and glued it in another spot. You can just mount the **** in the washer but it isnt quiet flush so you can see the nut that held it on, at least with mine. sry for the blurry pics
Ohh and you have to take the **** out of the factory casing or it wont fit.
I just got a washer painted it black and stuck it in the hole, then I made a plate out of some very thin sheet metal as a place for the switch to mount. I made the sheet metal so that it mounted to one of the screws that held the 4wd switch on and glued it in another spot. You can just mount the **** in the washer but it isnt quiet flush so you can see the nut that held it on, at least with mine. sry for the blurry pics
Ohh and you have to take the **** out of the factory casing or it wont fit.
Thread
Thread Starter
Forum
Replies
Last Post
monon43
General Technical & Electrical
1
08-25-2013 08:49 PM
lsf53
General Technical & Electrical
2
06-02-2010 04:30 PM
GVSU Godfather
Audio & Video Tech
23
05-29-2005 06:39 PM