Hey guys i just purchased a KENWOOD DX419 and i'm hoping to get it installed nice and clean. I had purchased a pyle 7 inch flip down monitor a few years ago and decided it was time for a little upgrade. When I installed the pyle into my 2003 ranger edge I trimmed the top and bottom lips on the radio bezel but they thing just wouldn't slide in. So I just slid it in from the front and it stuck out quit a bit. I've been doing some research and i'm hoping to get this thing in and have it look nice and clean. Does anyone have any suggestions or is it possible that the 7 inch flip down screen may have had different dimensions that the non fiip down. Thanks in advance and I must say your guys radio installs look fantastic.