Did I screw up, or what's the secret? (Fuel line connectors)
#1
Did I screw up, or what's the secret? (Fuel line connectors)
2003 2.3L >225K miles (with P0171)
Just replaced the fuel pump. When I pulled the fuel lines off the pump, I yanked the little clippie things all the way out. Can't seem to get them back into the connector on the end of the fuel line. I tried the old (somewhat deformed) ones. I've tried new ones (Dorman 800-015 or 800-023, I forget). What's the secret? Can't believe this job is held up by a cheap bit of plastic!
Just replaced the fuel pump. When I pulled the fuel lines off the pump, I yanked the little clippie things all the way out. Can't seem to get them back into the connector on the end of the fuel line. I tried the old (somewhat deformed) ones. I've tried new ones (Dorman 800-015 or 800-023, I forget). What's the secret? Can't believe this job is held up by a cheap bit of plastic!
#2
RF Veteran
iTrader: (1)
Thread
Thread Starter
Forum
Replies
Last Post
Reyn
2.9L & 3.0L V6 Tech
3
11-23-2015 11:00 AM
Want to Buy: Fuel line between fuel filter & fuel pump - TN
iplayloudly
OLD - Interior, Exterior, Electrical, & Misc.
7
05-02-2012 03:10 PM