91 ranger tranny problem
#1
91 ranger tranny problem
I have a 91 ranger 2.3 2 wheel drive. I bought it from a elderly man only has 70,000
Miles. But it has been sitting for almost 2 years in a garage here in North Florida. I got it up and running only problem is I let the clutch out and it barely moves like the clutch is bad. Fluid is full I do not hear any noises. The gentlmen told me it was working fine when he parked it.I know I should replace the fluid because it's been sitting but my question is could the fluid cause this problem. Doesn't sound like much fun dropping the transmission so i thought i would get some advice first.thanks
Miles. But it has been sitting for almost 2 years in a garage here in North Florida. I got it up and running only problem is I let the clutch out and it barely moves like the clutch is bad. Fluid is full I do not hear any noises. The gentlmen told me it was working fine when he parked it.I know I should replace the fluid because it's been sitting but my question is could the fluid cause this problem. Doesn't sound like much fun dropping the transmission so i thought i would get some advice first.thanks
#2
RF Veteran
iTrader: (1)
If clutch pedal "feels" OK, i.e. not stopping half way down, then you need a new clutch disc.
The clutch system(disc, pressure plate and flywheel) is by default engaged, the clutch pedal system is built to disengage the clutch disc(transmission) from the flywheel(engine).
A problem disengaging the engine from the transmission, i.e. hard to get into 1st when not moving or just hard shift to any gear while moving, would mean a problem with pedal system, master/slave or air in system.
A problem engaging would be in the clutch system, disc, pressure plate or flywheel
The clutch system(disc, pressure plate and flywheel) is by default engaged, the clutch pedal system is built to disengage the clutch disc(transmission) from the flywheel(engine).
A problem disengaging the engine from the transmission, i.e. hard to get into 1st when not moving or just hard shift to any gear while moving, would mean a problem with pedal system, master/slave or air in system.
A problem engaging would be in the clutch system, disc, pressure plate or flywheel
Thread
Thread Starter
Forum
Replies
Last Post
lifted97ranger
Drivetrain Tech
19
11-26-2007 12:12 PM
PickupMan92
General Technical & Electrical
4
07-31-2004 10:41 PM