Drivetrain Tech General discussion of drivetrain for the Ford Ranger.

Shaky Ranger from take off-top end

Thread Tools
 
Search this Thread
 
  #1  
Old 07-06-2011
FN Ranger's Avatar
Member
Thread Starter
Join Date: Jul 2011
Location: Memphis TN
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Shaky Ranger from take off-top end

I check the U-joints yesterday and they are tight with no play in them.

The truck is an 01 3.0 v6 with 197,000 on it.Its always had a small shake I could not nail down and so I lived with it but of the last 1000 miles its developed a shake that will shake the seats so bad that you want to not drive it any longer.The thing is its not so much in the steering wheel either but anything in the cab will shake and rattle all over.

I am down to thinking its the drive shaft.

Any other thoughts? Any had this happen before?

I searched around and did not find this exact issue.

Thanks
 
  #2  
Old 07-08-2011
pogi69x's Avatar
Member
Join Date: Aug 2010
Location: Anchorage, AK
Posts: 16
Likes: 0
Received 0 Likes on 0 Posts
Have you checked out your ball joints?
 
  #3  
Old 07-08-2011
Sbcjeep's Avatar
Member
Join Date: May 2011
Location: Canton, Michigan
Posts: 53
Likes: 0
Received 0 Likes on 0 Posts
Bad tires could be a shifted belt. Start with getting the tires balanced. Check the drive shaft for any weights that rusted off, u joints, and carrier bearing if it has one.
 
  #4  
Old 07-09-2011
FN Ranger's Avatar
Member
Thread Starter
Join Date: Jul 2011
Location: Memphis TN
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Pogi,

I rebuilt the front 6 months ago but I will look at them to see if one failed early.Thanks for your response!

SBC,

I am getting the tires and rims checked tomorrow for any bends and just as you said it might be a belt.I had the shaft balance checked and the U Joints replaced today.I pulled it in the garage and replaced an axle seal and rear brakes while I was at all this.There was a bad rear u joint but that only cured about 70% of the shake.I am as I said and you advised doing the tires and wheels tomorrow,will also check front wheel bearings and I will post an update.

Thanks for your advice!
 
  #5  
Old 07-09-2011
pogi69x's Avatar
Member
Join Date: Aug 2010
Location: Anchorage, AK
Posts: 16
Likes: 0
Received 0 Likes on 0 Posts
I am in the process of re doing the front end myself, I would think that a front end would last a little longer than 4 years. But I guess once one item goes unless it's repaired quickly the rest would soon follow. I am learning more about repair and trouble shooting now as I'm doing it myself. I hope you find the problem quickly.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
sheen
General Ford Ranger Discussion
14
12-09-2011 09:01 PM
anakasarda13
General Ford Ranger Discussion
0
05-28-2011 11:52 AM
BRICK99
2.9L & 3.0L V6 Tech
7
01-03-2011 08:49 AM
ranger_1999
General Ford Ranger Discussion
9
08-28-2008 04:00 AM
CROMERANGER
New Ideas
9
03-18-2006 05:29 PM



Quick Reply: Shaky Ranger from take off-top end



All times are GMT -6. The time now is 05:49 PM.