Bearings, lots of them
#1
Bearings, lots of them
So I'm trying to get all the parts needed for my 4x4. I just bought my locker for my front end and I have a minor install kit. (no i won't be doing the install of these things) I understand that in the 3rd member you have bearings and races for the diff itself, then you have an in and out side bearing for the pinion. Is there a bearing/race setup on the outside of the 3rd member case where the axles go in? Also how about the bearings inside the knuckle. Those are shot and need to be replaced. After that I have to get new rotors (going to try some ebay drilled and slotted this time) and then bearings and races for that.
Am i missing anything?
Am i missing anything?
Thread
Thread Starter
Forum
Replies
Last Post
dhassay
2.3L & 2.5L I4 Tech
29
09-17-2009 08:50 PM
Fx4wannabe01
Interior Semi-Tech
16
02-16-2007 12:39 PM