Image of Transmission fluid leak.
#1
Image of Transmission fluid leak.
What would need to be done about this?
I have not changed trans fluid yet, and was wondering if I should run a leak stop prior to changing the fluid, or to change it and see if it stops leaking?
It doesn't leave any signs while parked of a leak, but I imagine while driving it leaks a bit.
#3
#9
It's back after the 30 mile drive, nearly exactly the same look.
This whole measure, mark, drop thing sounds easier than it looks...
Starting to really like this guy, lol.
How to Index & Remove a Drive Shaft: Replacing a Rear Axle U Joint | eHow.com
Installing a Drive Shaft to the Transmission: Replacing a Rear Axle U Joint | eHow.com
This whole measure, mark, drop thing sounds easier than it looks...
Starting to really like this guy, lol.
How to Index & Remove a Drive Shaft: Replacing a Rear Axle U Joint | eHow.com
Installing a Drive Shaft to the Transmission: Replacing a Rear Axle U Joint | eHow.com
Last edited by Hawklore; 04-21-2010 at 03:21 PM.
#10
#11
Member
iTrader: (1)
Join Date: Dec 2009
Location: kalamazoo, Michigan
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
ive got this same leak!! more info would be nice. do u have to drain any fluids beforehand? and just drop the driveshaft, and the seals right there? also is this what i would buy to fix this leak...
http://www.partsgeek.com/gbproducts/...ek+Google+Base
http://www.partsgeek.com/gbproducts/...ek+Google+Base
#12
#16
the one you posted is for a f-150 you need this one
02 2002 Ford Ranger Transmission Case Shaft Seal - Transmission - Timken - PartsGeek
and put loctite on the splines of the output shaft before installing the flange
02 2002 Ford Ranger Transmission Case Shaft Seal - Transmission - Timken - PartsGeek
and put loctite on the splines of the output shaft before installing the flange
#17
Member
iTrader: (1)
Join Date: Dec 2009
Location: kalamazoo, Michigan
Posts: 420
Likes: 0
Received 0 Likes
on
0 Posts
the one you posted is for a f-150 you need this one
02 2002 Ford Ranger Transmission Case Shaft Seal - Transmission - Timken - PartsGeek
and put loctite on the splines of the output shaft before installing the flange
02 2002 Ford Ranger Transmission Case Shaft Seal - Transmission - Timken - PartsGeek
and put loctite on the splines of the output shaft before installing the flange
oh and im guessin even though its for an 02 itll fit my 01?
#22
Update. I just looked under my truck because I was going to replace the transmission mount. Same LEAK as pictured above.
Just want to verify that this seal will fit the 2.3L auto before I order it.
I am on rock auto and I see the following:
More Information for SKF 13685
Transmission seal under Automatica transmission.
IF I scroll down to Transfer case I see output shaft seal however nothing indicating RWD...etc.. all for 4wd.?
Want to amek sure I get the right thing.
SKF 13685 Automatic Transmission Rear Seal | eBay
When looking at mine it has a boot that the shaft then goes into.
Thanks much,
-Nigel
Just want to verify that this seal will fit the 2.3L auto before I order it.
I am on rock auto and I see the following:
More Information for SKF 13685
Transmission seal under Automatica transmission.
IF I scroll down to Transfer case I see output shaft seal however nothing indicating RWD...etc.. all for 4wd.?
Want to amek sure I get the right thing.
SKF 13685 Automatic Transmission Rear Seal | eBay
When looking at mine it has a boot that the shaft then goes into.
Thanks much,
-Nigel
Last edited by NewShockerGuy; 01-18-2014 at 11:06 PM.
Thread
Thread Starter
Forum
Replies
Last Post