tranny help- fluid line removal
#1
tranny help- fluid line removal
I have a rebuilt tranny installed in my 2004 4.0 Ranger. Manual. I have to replace the fill line. Its the piece that you fill with brake fluid. It has a fill cap, goes into the firewall to the clutch pedal, then goes into the slave cylinder in the tranny.
How does that piece disconnect from the firewall? the haynes manual states nothing about it.
How does that piece disconnect from the firewall? the haynes manual states nothing about it.
#4
Manuals fill from the side of the tranny.
But
Some have removed the shifter and filled from there.Have someone under the truck watching the fill plug on the side of the tranny for fluid coming out.
OOPs ! Too many beers I didn't read the OP right .
He's talking about the clutch system.
The line going to the master cylinder disconnects from it by removing a roll pin.
But
Some have removed the shifter and filled from there.Have someone under the truck watching the fill plug on the side of the tranny for fluid coming out.
OOPs ! Too many beers I didn't read the OP right .
He's talking about the clutch system.
The line going to the master cylinder disconnects from it by removing a roll pin.
Last edited by OTRtech; 07-03-2009 at 09:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post
BlackNGoldRules
General Technical & Electrical
7
02-06-2023 01:58 PM
ttb_addict94
Drivetrain Tech
0
06-05-2014 05:43 PM
greensystemsgo
General Ford Ranger Discussion
3
07-16-2010 09:13 PM
PickupMan92
General Technical & Electrical
4
07-31-2004 10:41 PM