Drivetrain Tech General discussion of drivetrain for the Ford Ranger.

messed up 4wd.. pos

Thread Tools
 
Search this Thread
 
  #1  
Old 02-05-2007
99ranger4x4's Avatar
RF Veteran
Thread Starter
iTrader: (3)
Join Date: Jun 2006
Location: Austin, TX
Posts: 12,198
Likes: 0
Received 3 Likes on 3 Posts
HELP, 4WD being stupid!

Im not sure if this goes here or in the Electrical.. but w/e heres my problem:

MY 4wd works.. but it jumps out of 4wd all the time, i think as long as i keep moving it stays in 4wd, as soon as i slow down or stop it jumps out

WTF is going on? solenoid?
that and the driveside CV shaft doesnt spin as fast as the passenger, maybe due to the fact that the hub assembly is going out..

could it possibly be that theres a vacuum leak thats making it come out of 4wd?

>>it just pops out, no warning, i try and go over a rock or something and my rear tires end up being the only ones turning.. I HATE IT!!!!



Pulse **** is goin bye bye soon enuf...AVM hubs are quite a bit cheaper than i expected.. 100 a set? im guessing ill need some kind of install kit too?


1999 4.0 5-speed
 

Last edited by 99ranger4x4; 02-05-2007 at 11:42 PM.
  #2  
Old 02-06-2007
99ranger4x4's Avatar
RF Veteran
Thread Starter
iTrader: (3)
Join Date: Jun 2006
Location: Austin, TX
Posts: 12,198
Likes: 0
Received 3 Likes on 3 Posts
anyone? lol
 
  #3  
Old 02-06-2007
IronRanger92's Avatar
Member
Join Date: Jul 2006
Location: SC
Posts: 244
Likes: 0
Received 0 Likes on 0 Posts
just take the clips out and see what happens.. i did the same.. damn PVS sucks some ***.. going for the same hubs as well. Far as the 4wd goes.. could be anything.. run a diagnostic.. lights flashing? have the computer scanned just in case
 
  #4  
Old 02-06-2007
99ranger4x4's Avatar
RF Veteran
Thread Starter
iTrader: (3)
Join Date: Jun 2006
Location: Austin, TX
Posts: 12,198
Likes: 0
Received 3 Likes on 3 Posts
nothing flashing.. the light comes on and says its in 4wd, and i can hear it pop/click into 4wd..

i already have that mod where u pull the little metal clip out..
 
  #5  
Old 02-07-2007
IronRanger92's Avatar
Member
Join Date: Jul 2006
Location: SC
Posts: 244
Likes: 0
Received 0 Likes on 0 Posts
could be a pill.. check em and see if the plastic hubs are broke
 
  #6  
Old 02-07-2007
99ranger4x4's Avatar
RF Veteran
Thread Starter
iTrader: (3)
Join Date: Jun 2006
Location: Austin, TX
Posts: 12,198
Likes: 0
Received 3 Likes on 3 Posts
i had em off the other day trying to find a squeak, the passenger side one was mashed together, i guess i messed that up when i was putting it back together the first time..

im gonna go through and clean all the wires on the t-case friday..and saturday if i get a chance to get my truck on a lift ill take a look at the hubs again
 
  #7  
Old 02-07-2007
99ranger4x4's Avatar
RF Veteran
Thread Starter
iTrader: (3)
Join Date: Jun 2006
Location: Austin, TX
Posts: 12,198
Likes: 0
Received 3 Likes on 3 Posts
i know it goes into 4wd, i can feel the lower gearing in 4low. would a vacuum leak cause it to jump out of gear? or a hub going bad?
 
  #8  
Old 02-07-2007
99ranger4x4's Avatar
RF Veteran
Thread Starter
iTrader: (3)
Join Date: Jun 2006
Location: Austin, TX
Posts: 12,198
Likes: 0
Received 3 Likes on 3 Posts
just got back from advanced, the guy may know, or he may b an idiot, anyways he said a vacuum leak could cause it.. so hopefully the new hub assembly and avm will cure it
 
  #9  
Old 02-07-2007
shadyluke's Avatar
Member
Join Date: Mar 2005
Location: West Grove, PA
Posts: 2,077
Likes: 0
Received 0 Likes on 0 Posts
if you pulled the clips then vaccuum shouldn't matter anymore. You may just have a blown hub or a damaged one if the one was mashed together.
 
  #10  
Old 02-07-2007
99ranger4x4's Avatar
RF Veteran
Thread Starter
iTrader: (3)
Join Date: Jun 2006
Location: Austin, TX
Posts: 12,198
Likes: 0
Received 3 Likes on 3 Posts
Originally Posted by shadyluke
if you pulled the clips then vaccuum shouldn't matter anymore. You may just have a blown hub or a damaged one if the one was mashed together.

so the vacuum has nothing to do with the t-case popping out of 4wd?
 
  #11  
Old 02-08-2007
IronRanger92's Avatar
Member
Join Date: Jul 2006
Location: SC
Posts: 244
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by 99ranger4x4
so the vacuum has nothing to do with the t-case popping out of 4wd?
exactly.. its still bad you have a vacuum leak.. so i'd take the time to find it and block it off.. as well as replace the hubs.. which should be why its not pulling
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
fx4wannabe
Miscellaneous Items
3
03-03-2010 11:54 PM
siri
4.0L OHV & SOHC V6 Tech
9
04-03-2008 10:12 PM
Wertzy
General Ford Ranger Discussion
21
05-03-2007 10:38 PM
JCS30TH
General Ford Ranger Discussion
25
11-10-2005 03:17 PM



Quick Reply: messed up 4wd.. pos



All times are GMT -6. The time now is 11:05 AM.