Loud whining after slave replacement
#1
Join Date: Apr 2009
Location: clinton,mississippi
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
#3
Join Date: Apr 2009
Location: clinton,mississippi
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
no could that be it. the noise gets louder with the rpms and its not exhaust i put a screw driver up to the transmission to listen and you can hear the noise around the bell housing but when you put it up to the bleeder valve or the line you can hear it like you can on the bell housing.
#4
Member
iTrader: (11)
Join Date: Jan 2005
Location: West Topsham, VT
Posts: 1,709
Likes: 0
Received 0 Likes
on
0 Posts
no could that be it. the noise gets louder with the rpms and its not exhaust i put a screw driver up to the transmission to listen and you can hear the noise around the bell housing but when you put it up to the bleeder valve or the line you can hear it like you can on the bell housing.
#5
Join Date: Apr 2009
Location: clinton,mississippi
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
it does it with both could it be maybe a cheap slave and it being new be rubbing something it cost 92 dollars i didnt get to get it i had a buddy pick it up for me is that a cheap on or is it mid grade or what
#7
LOL........oh I know that noise. I replaced the slave a few years back along with a new clutch kit........only thing I didn't know was to replace the pilot bearing while in there. The little thing makes some noise with the clutch disengaged and with the trans in neutral. Not so bad in a gear though.
#8
Join Date: Apr 2009
Location: clinton,mississippi
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
LOL........oh I know that noise. I replaced the slave a few years back along with a new clutch kit........only thing I didn't know was to replace the pilot bearing while in there. The little thing makes some noise with the clutch disengaged and with the trans in neutral. Not so bad in a gear though.
Thread
Thread Starter
Forum
Replies
Last Post
lifted97ranger
Drivetrain Tech
21
01-17-2014 10:38 PM
Intents000
Drivetrain Tech
5
09-28-2011 11:42 PM