Right Hub & Bearing Frozen Together
#1
Right Hub & Bearing Frozen Together
Went to replace the ball joints, wheel bearings and tie rods. Did the driver's side first. Not too bad took longer then expected but no big deal.
The passenger side though is another story. The hub assembly would not come off normally so I finally turned the cap CCW and released it in pieces. The cap, spring and white plastic pieces came out but the gears seem to be frozen onto the axle shaft.
Any ideas on how to proceed from here so I can get to the retaining clip to separate the bearing assembly from the axle shaft?
2000 4x4 156,000 miles 4.0 manual
Thanks
Chris Sr.
The passenger side though is another story. The hub assembly would not come off normally so I finally turned the cap CCW and released it in pieces. The cap, spring and white plastic pieces came out but the gears seem to be frozen onto the axle shaft.
Any ideas on how to proceed from here so I can get to the retaining clip to separate the bearing assembly from the axle shaft?
2000 4x4 156,000 miles 4.0 manual
Thanks
Chris Sr.
#5
#6
start a photobucket account for free and upload and just copy and paste image code under uploaded pictures on photobucket account
Thread
Thread Starter
Forum
Replies
Last Post
Jeremy102579
General Ford Ranger Discussion
8
10-18-2006 10:00 PM