New clutch installed but now does not disenguage!
#1
New clutch installed but now does not disenguage!
Ok so i just yanked the trans out of my ranger because it needed a clutch. So i put one in and reinstalled everything 2 day, now the clutch will not disengauge. Its a 1999 2.5 single cab short bed ranger with 208k miles on it. I changed the throw out bearing,clutch and pressure plate. I had to remove the hydraulic line to pull the trans, does it have to be bled after i did this because my buddie has the same truck and he didnt have too. But im just stuck because i dont have a truck to drive and i put everything back together and and put new fluid in the trans. HELP PLEASE!!!!
here is some pics of the truck
here is some pics of the truck
Thread
Thread Starter
Forum
Replies
Last Post
k00kiem0nster
SOHC - 2.3L & 2.5L Lima Engines
9
06-01-2014 01:00 PM
DJDev
Drivetrain Tech
2
10-28-2012 08:41 PM
atmu5fear
General Technical & Electrical
3
11-28-2011 09:11 PM
BmillerEdge
General Technical & Electrical
1
12-29-2010 09:37 AM