4X4 not working
#1
4X4 not working
I've read everything I could find on this site about 4X4 problems and solutions. I cannot pin point the problem. Both the 4-LO and 4-HI lights come on right after starting and then go off. I can hear the clicking noise when I turn it to 4-HI and the light comes on. When I switch it to 4-LO there's no clicking and the light does not come on. There's no doubt that its not pulling in 4X4. I checked all the fuses and the fluid. No idea what's wrong.
Please Help!
Please Help!
#5
When you turn the switch to put it into 4x4 hi/lo, make sure #1 it is in neutral.. and #2 the transfer case will not engage unless you have your foot on the brake. Well, that is, if your putting it in 4X4 Lo, not sure about 4X4 Hi. Sorry, that may be obvious, but it's a simple mistake a lot of guys make! Lol! Good luck!!
#6
Thread
Thread Starter
Forum
Replies
Last Post
ColinGooseHall
General Technical & Electrical
8
10-08-2023 02:41 PM
jfoster2505
General Technical & Electrical
3
02-14-2012 07:23 PM