Not sure for this problem
#1
Not sure for this problem
Leaking brake fluid BAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAD, its leaking out from the passenger side wheel on the inside.
I was told I need, either it was called a brake cylinder or wheel cylinder, anyone able to confirm this.
Its so bad the truck is nearly unable to stop, brake to the floor and everything
I was told I need, either it was called a brake cylinder or wheel cylinder, anyone able to confirm this.
Its so bad the truck is nearly unable to stop, brake to the floor and everything
#3
#4
9" has heat dissipation fins on the outside of the drum, 10' does not.
Wheel cylinder replacement isn't too hard. Get yourself some flair wrenches for the fitting. Don't try to turn the fitting with increasing pressure like an ordinary fastener. Use the flare wrench and give it a sharp snap right off the bat. Also helps to soak it in some PB Blaster well prior, then wipe it dry for the wrench.
I'd replace those fluid-soaked shoes while you are at it.
2wd is likely 9".
Read up on bleeding brakes!
Wheel cylinder replacement isn't too hard. Get yourself some flair wrenches for the fitting. Don't try to turn the fitting with increasing pressure like an ordinary fastener. Use the flare wrench and give it a sharp snap right off the bat. Also helps to soak it in some PB Blaster well prior, then wipe it dry for the wrench.
I'd replace those fluid-soaked shoes while you are at it.
2wd is likely 9".
Read up on bleeding brakes!
#5
Thread
Thread Starter
Forum
Replies
Last Post
Traveler5
General Ford Ranger Discussion
16
04-30-2020 01:54 PM
Wowak
Ranger-Forums Office
6
08-04-2004 01:13 AM