Manual transmission problems. Need advice!!!
#1
Manual transmission problems. Need advice!!!
I have a 2002 2wd ranger with a 3.0 engine and a 5 speed manual transmission. Since I bought the truck at 40,000 miles the transmission has had a rattling noise when left in neutral with the clutch engaged. This noise has recently started to sound more... nasty for lack of a better word. Today it started becoming difficult to shift gears. And while in gear with the clutch pushed in I could feel a little pulsing or vibrating as if the clutch wasn't pressed in all the way. Also when in gear with the clutch pushed in there is a similar rattling noise as the one that occurs when in neutral.
I had the clutch and master cylinder replaced at 75000 miles, although i'm not sure i trust the work that was done. The truck currently has 152000 miles.
Have my input shaft and throwout bearings gone bad? Any advice is much appreciated.
I had the clutch and master cylinder replaced at 75000 miles, although i'm not sure i trust the work that was done. The truck currently has 152000 miles.
Have my input shaft and throwout bearings gone bad? Any advice is much appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
watsonlora58
Member Introductions
9
08-27-2011 09:08 AM
04blackedge
OLD - Interior, Exterior, Electrical, & Misc.
1
05-07-2009 04:43 PM