Headlight mod Question
#1
Headlight mod Question
so i have been thinking about doing the headlight mod on my truck, and was thinking, would it be a good idea to use a heat gun to melt the glue or use the oven? the only thing i can think of is that the heat gun would be too direct and warp the light. where as the oven would heat it slowly and uniformly.
what are your thoughts?
what are your thoughts?
#2
#5
#8
Originally Posted by bondoford
whats this mod?
http://www.generation-edge.info/topic.asp?TOPIC_ID=641
#10
#11
Originally Posted by FMD
what temps did you use, and about how long before u could pry em apart?
The factory 06/07 corners got 190F, heated twice for 10 minutes to separate.
Originally Posted by rwenzing
Here are pics of the stock and modified 06 corners. I just followed the headlight mod instructions here, being careful not to pry too hard. I had to heat them twice for 10 minutes at 190F to get them to fully separate. The background and the rim of the clear lens were then painted satin black before reassembly.
Original:
Modded:
Original:
Modded:
Thread
Thread Starter
Forum
Replies
Last Post
silverfox
General Technical & Electrical
8
09-23-2009 02:20 PM
Wowak
General Ford Ranger Discussion
24
05-06-2005 10:25 AM