light tabs
#1
#7
i have a set on the way, but i put the ones i made on for a sec, and i pulled the grill. i used a socket on the drivers side and a racheting box wrench on the passanger because of the transcooler. i suggest spraying some penatrating lube on them to ge tthe rust off. now who mount the lights then mount the tabs? or do you mount the lights after the tabs?
#8
#11
#13
There'll probably look like stairs. I don;'t know how the 98-00 grilles attach...but on a 01-08, the header panel will be in the way. I dont think there's any way to modify a set of tabs to make it work the way you want. The lights won't fit in the grille if it just goes straight up....i'm sureit can be done, if completely different brackets are made.
#15
Thats not a bad idea Ory. I think they will be too far apart though unless you connected a bar to them to relocate the lights closer to the center. The other thing that crosses my mind would be the tranny cooler. Not sure if that would get in the way if you have an automatic. You have me interested enough to take a peek behind the grill.
#16
i just ordered light tabs and i have a westin safari bar.. will the lights still fit? i have 6" kc day lighters.. i noticed flyinfx4 has the tabs and the arched 4 bar but he has a bull bar and his semed to fit fine.. im wondering if all i have to do is put some washers in the tabs to make the lights sit up higher, but im more woryed about how far they will stick out im hoping they wont hit the bar.. dose anyone know if i will have problems??
#17
Jason, send me some measurements and I'll make them per your specs. You should be able to place a tape measure to the back of the bumper and let me know how far out it can go before hitting. My Bracket comes out 6" with the center of the hole at 5" from the back of the bumper.
This will show you the general location of where the tabs come out:
http://stuffforyourranger.com/How_To...httabsbar.html
This will show you the general location of where the tabs come out:
http://stuffforyourranger.com/How_To...httabsbar.html
#20
Jason, send me some measurements and I'll make them per your specs. You should be able to place a tape measure to the back of the bumper and let me know how far out it can go before hitting. My Bracket comes out 6" with the center of the hole at 5" from the back of the bumper.
This will show you the general location of where the tabs come out:
http://stuffforyourranger.com/How_To...httabsbar.html
This will show you the general location of where the tabs come out:
http://stuffforyourranger.com/How_To...httabsbar.html
Thread
Thread Starter
Forum
Replies
Last Post
annguyen1981
OLD - Interior, Exterior, Electrical, & Misc.
28
12-25-2011 06:42 PM
Sonic04Edge
General Ford Ranger Discussion
18
12-14-2005 12:42 PM