No pics but I took a std 2x2 ball mount and welded a piece of flat stk over the ball mount hole and then three pieces of tubing are mounted upright to mount the flag poles.
The ID of the tubing is sized for the Flag Pole OD and the end two are bent a little towards the rear and outward towards the sides of the truck.
This spreads the flags out and keeps the center flag up higher and straighter the US Flag that is.
I run the US Flag in the middle, the POW Flag on the driver’s right and the MA State Flag on the left.
Weather is getting warmer I will attempt to get some pics.
4x4, 5sp, Std Cab, Stepside, E4 Red
4” Lift - Coil-Overs, 6” SkyJacker Leafs - No Blocks (Mistake)
31 Spline FX4 Rear Axle, 4.56s and OX Locker, Hurst Shifter w/Optional Stick and "Made by Grev" alignment adapter