LED Washer Nozzles
#1
Finished: Painting Grille and bumper
I attempted to install LED washer nozzles in my 99 Ranger last week and was able to get one in but not the other. I could easily get the drivers side nozzle in but not the passenger side because it's being blocked by the computer, and seems nearly impossible to get to. Has anyone done this know how to get around it?
#4
#5
Originally Posted by Pinecone
I know on the Edge's it would be completely pointless to put them on cause the hood would be in the way. I am not sure how the 99 hood is shaped off hand, will you even be able to see the nozzles?
#6
#8
#10
Taken the computer out too, it's enclosed where the computer is held. The only thing i could think of is to take out the top piece where all of the little holes are right around the windsheild wipers, but i havent a clue on how to do that.
EDIT: I've seen them on other Ranger's on CarDomain, and i wish i still had the links, i would ask them.
EDIT Again: http://www.cardomain.com/ride/319911
It's possible
EDIT: I've seen them on other Ranger's on CarDomain, and i wish i still had the links, i would ask them.
EDIT Again: http://www.cardomain.com/ride/319911
It's possible
Last edited by Diabolic; 08-28-2005 at 08:15 PM.
#11
Member
iTrader: (5)
Join Date: May 2005
Location: Jackson, New Jersey
Posts: 4,872
Likes: 0
Received 0 Likes
on
0 Posts
I recognize the truck, he's a member on here if you didn't know. Darkstarskate < that'll bring you to his profile. You can email him, pm him, or maybe catch him on AIM. He hasn't been active in a while, but you might be able to catch him that way.
#12
Originally Posted by winks
I recognize the truck, he's a member on here if you didn't know. Darkstarskate < that'll bring you to his profile. You can email him, pm him, or maybe catch him on AIM. He hasn't been active in a while, but you might be able to catch him that way.
Thread
Thread Starter
Forum
Replies
Last Post