Hi Mr. Griffin.
My close local friend, Kyle, did a Raptor-like fender, bedside, and hood conversion. It was made by McQueen Prototype Design down in Southern California. It takes styling cues from the Raptor like the fender flare body line as well as the hood with the louvers. But retains the Ranger grille, headlights, and taillights. It's also a more minimal approach to fiberglass fenders...without going overly wide, overly large, or too cartoony/gawdy. Installation was fairly straight forward and the lines line up almost perfect. Front fenders were almost dead on the first try. Bedsides required a little bit more.
DaRangerDanger's 2003 2wd Edge...
This is the truck I was referring to in another one of your threads about 15x10's and spindle lifted Edge. This is what fiberglass fenders and bedsides look with a 3" spindle lift, 15x10's (-44 offset), and 35x12.50R15 tires. 3.0 5spd manual and 4.56's.