Will a rear bumper from a Explorer Fit?
#29
#34
#36
To be perfectly honest I doubt I will actually sell it anytime soon. I have only a select set of vehicles I would trade for and as far as cash goes I really won't take less than 8500.
back on topic. I am looking for a plasma cutter. anyone know where to get a good deal. I hope to get the bumper on there soon. I decided to cut it down some more too. I want to make it completely flush almost. Sticking out about 3 inches.
Of course my hand is still limiting the amount of work i can do. Also hopefully they wont do surgery on it cause that will have a long recovery time too.
back on topic. I am looking for a plasma cutter. anyone know where to get a good deal. I hope to get the bumper on there soon. I decided to cut it down some more too. I want to make it completely flush almost. Sticking out about 3 inches.
Of course my hand is still limiting the amount of work i can do. Also hopefully they wont do surgery on it cause that will have a long recovery time too.
Thread
Thread Starter
Forum
Replies
Last Post
BlackRanger04
OLD - Interior, Exterior, Electrical, & Misc.
10
12-11-2010 05:26 PM
lownslow95
Exterior Semi-Tech
7
11-05-2009 09:42 AM