Bent Rear Fenders
As the title says I bent not just one but both of my rear fenders, nothing too major. I cracked a little bit of the paint and DO NOT want it to spread, and I was also curious how I can bend them back? (Rubber martlet etc.) The bend on both sides is towards the front of the truck on the bottom half and are about a half dollar bent out.
Your feedback is very important, because I need to get this done ASAP before the chipping gets worse, I'd also like to know if there is a spray or compound I can use on it to keep the spreading of the chipping to a minimum and for it not to rust.
Ford Ranger, 4.0 V6 SOHC, 31.5 BFG AT's with Datona Wheels, K&N Intake and Magnaflow Exhaust, 6k Heads, LED Running, 3k Fogs, 06 Tails, Corners, Emblems, Cobra CB w/ Firestick,10" Sub with Pioneers all around. OREGON Ranger