is anyone running this bumper? if so whats your opinion of it? Pics are helpful, especially of how it mounts.

 

What bumper? lol

 

Check out this thread: Custom4x4Fab Bumper

 

custom4x4fabrication.com they make a winch bumper for the rangers. the pics online suck but i just found that Sea Bass has the bumper. im really just curious of how it mounts and how hard it would be to modify for a body lift.

 

your the man thats what i was looking for!

 

Now if we can get them to make a rear bumper, especially for a Steppie.

I have one of the bumpers but not on yet, third thing on the list to install.
Just need the rear.

 

Hey Grev, got any pictures of the mounting points?

 

Will TRY to get some today.
I am not good at getting picture when asked so time will tell.

 

It doesn't come with mounting points does it?

 

No pics yet, had an Eye Doctor’s Appointment and the eyes are still blurry.

The bumper comes with the mounting built in the bumper and all of the hardware and bracing to mount it to a Ranger, at least to an ’03 Ranger.

 

i checked out that bumper.... i dont like it much it needs a skid plate to go under it other wise it wont do much good off road when your running over stuff

 

any luck with those mount pics?

 

tomorrow first thing, sorry.

 

Ok here are the pics of the Bumper side of the mounting, I have not unpacked the Mounting Kit yet.
If pics of the Mounting Kit is needed let me know.

Rear View both mounting points.


Top View of the Driver’s Side



Driver’s Side Rear View of Mounting Point:



Same Side low view:



Same but from the side:



Hope these help someone.

Sorry for taking so long.

 

ok i really want one now. what did it run you shipped if you dont mind me askin?

 

$162.50 to MA.

 

not bad. now lets see it on the truck

 

Yea right, it is on the list, new tunes first, wiring for the Sub, Pwr Windows and then locks and then the bumper frt and then the rear (working on getting that one), then the STX Grille Mod for an ’03 (thks to P.C.).

Working on ideas for 5.0 and SAS… too many ideas and too little time.

The front bumper should happen this spring but only time will tell.

 

how u going to do a 5.0 in MA with emissions and other stuff etc

 

If you keep everything in the electronics package and the engine is running well, the computer will accept the data and not question which engine is there.
The Test Computer just want certain responses from the ECM in the emissions area from your truck and as long as it gets the correct codes it a go.
Get a good engine, tune it well and keep it tuned and the oil changed and you should be able to pass.

Now there are other methods but we can’t go into those here but it will work.

 

pretty long list you got there

 

Tell me about it; hope to get some done over the next week or so, warm weather for sure.

 

how much does that bumper weigh?

 

Not sure how much it weigh in at.
Guessing 100 maybe 125 lbs.
Can’t find the weight on the C4x4 Site

 

damn its pretty beefy