Alcoa guys!
#1
Alcoa guys!
I was going to PM one of you. but i can't find anyone off hand in the portal with a set.
Can somebody so me a HUGE favor? I need you to measure the inside diameter of the wheel too see if a 4x4 hub like mine would fit in between there.
Just the spot where your center cap covers. I was gonna look at the set i posted on the CL find later this week. but i wanna be sure before i go out and waste some time.
Can somebody so me a HUGE favor? I need you to measure the inside diameter of the wheel too see if a 4x4 hub like mine would fit in between there.
Just the spot where your center cap covers. I was gonna look at the set i posted on the CL find later this week. but i wanna be sure before i go out and waste some time.
#5
#6
#7
#8
I bored out Holes once for these hubs, Its a PITA and i went thru like two chisel bits (I used metal sanding bits the tool guy said would do the job)
If they aren't worth the time (two are half painted black) Then i'll just save the 100 bucks and whatever else i'll spend taking the paint off/polishing them up and buy Classic 2s
If they aren't worth the time (two are half painted black) Then i'll just save the 100 bucks and whatever else i'll spend taking the paint off/polishing them up and buy Classic 2s
Thread
Thread Starter
Forum
Replies
Last Post
Oh2Ranger
OLD - Interior, Exterior, Electrical, & Misc.
0
02-13-2011 01:10 AM
Redneckstone
Wheels & Tires Semi-Tech
13
10-07-2006 02:53 PM