Reg Cabs are small in 93 so you will be limited.
Explorer Seat, IMHO, will be too big.
Maybe this bump will get some responses.
Measure and test fit.
I have a Reg Cab 03 and the Explorer Seat were too high and too long on the bottom so it ended up as a tight fit. Decided to swap the seat with 99offroadrngr for std Ranger seats.
The OEM seats are great, just got some new covers and cushions for them I think they are the best bet.
Not sure about the ’93 but in ’03 the tracks will unbolt from the seats, the passenger side seat is no more than a driver’s side seat and the track and all ***** will swap. If your seats are like the ‘03s then you might find a good pair of passenger seats, clean them up or add new covers and you will have a set of buckets.
Again, I am not sure of how the ’93 seats will swap but check it out.
4x4, 5sp, Std Cab, Stepside, E4 Red
4” Lift - Coil-Overs, 6” SkyJacker Leafs - No Blocks (Mistake)
31 Spline FX4 Rear Axle, 4.56s and OX Locker, Hurst Shifter w/Optional Stick and "Made by Grev" alignment adapter