97 Ranger Break problems - Ranger-Forums - The Ultimate Ford Ranger Resource
Ford Ranger Forum - Forums for Ford Ranger enthusiast!

Go Back   Ranger-Forums - The Ultimate Ford Ranger Resource Arrow Ranger-Forums General Forum Arrow General Ford Ranger Discussion

General Ford Ranger Discussion General discussion of the Ford Ranger that does not fit in any other sub-forum.

LinkBack Thread Tools Search this Thread
Old 12-21-2012
Thread Starter

I am: Andrew Hazelet
Join Date: Dec 2012
Location: East Liverpool Ohio
Vehicle: Ford Ranger 97
Posts: 1
Total Props: 0
97 Ranger Break problems

I have a 97 ranger 2.3l 5spd in decent condition with around 220k mi. Ever since I got it in the rain especially the front breaks were a little touchy and grabbed easily. I have replaced all the pads front and rear, rotors and drums are good. I replaced all the rear break lines and cylinders because they went bad. The front seems to be grabbing a little harder then usual (no front ABS so they are gonna lock if you slam them of course...). I wrecked two years ago in the snow because pf these stupid breaks... But The one thing that has made me sort of rule out problems that I have read, is that if I am going 5-10 mph, and ride the brakes for a second or two... The problem completely disappears until pretty much the next time I drive it. No mater rain or snow, if I do that it always corrects the prob. I know for sure that's hell for the drivetrain and breaking system.. So I was wondering what someone though this problem could be.. What would cause me to have to heat them up to stop grabbing ..
Thanks in advance for any responses they are greatly appreciated.
Reply With Quote
+ 0 -

Similar Threads
Thread Thread Starter Forum Replies Last Post
Lunch break: Ranger Extracts Full Size Chevy n3elz General Ford Ranger Discussion 17 01-06-2007 01:06 PM
Ranger break-in period? ericsmith32 General Ford Ranger Discussion 8 07-09-2006 06:25 PM
Disk break Conversion for Ranger BliZZarDx23 Suspension Tech 24 04-01-2006 11:55 AM
headlight bulbs...break it down for me..i dont understand... TippnOver Exterior Semi-Tech 74 01-29-2005 12:22 AM

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -6. The time now is 04:44 PM.