OHC WTF!!! need some help please
#1
OHC WTF!!! need some help please
ok, going through installing my overhead console, it all works nice, but i dont have the wire mentioned to hook up the speed sensor, so what can i do? it says hook it to the grey w/ black stripe in the smart junction box on the pass side. My truck doesnt have this wire to connect to!
options?
also, my thermometer says its 18F outside, when its probably 65.
whats wrong here, and how do i fix it?
ive done all the resets, holding the mode button and all.
let me know the fixes for these problems if you know whats up! thanks!
options?
also, my thermometer says its 18F outside, when its probably 65.
whats wrong here, and how do i fix it?
ive done all the resets, holding the mode button and all.
let me know the fixes for these problems if you know whats up! thanks!
Last edited by 06RangerXLT; 03-18-2012 at 07:20 PM.
#4
ok, going through installing my overhead console, it all works nice, but i dont have the wire mentioned to hook up the speed sensor, so what can i do? it says hook it to the grey w/ black stripe in the smart junction box on the pass side. My truck doesnt have this wire to connect to!
options?
options?
#6
#7
#11
Nate you can use Pin 3 (GY/BK) on the cruise servo plug, Pin 52 (GY/BK) on the main harness(coming into the truck from engine) or Pin 68 (GY/BK) on the PCM Plug on the firewall. They are all GY/BK VSS wires, the easiest one to use is the one in the main harness inside the truck. All info pulled from the Ford Factory Service Manual.
#19
Thread
Thread Starter
Forum
Replies
Last Post
94greenmachine
General Ford Ranger Discussion
4
01-16-2009 09:18 PM