bench seat swap in 1998 rangers?
#5
#6
#7
I know in my year ranger the seat belts have a sensor on the end and if not used can throw an engine code. Lap belts should work as long as its plugged in to the old seat belt part. As fas as a harness you will need to do a little more work but its doable some people on the site are running them. A harness with a bench seat I dont know about that.
Mine came out of a mini van and tilts forward for storage behind it which is nice. I keep recovery gear back there.
I would just remove the old bench seat and start comparing brackets and see if it is a direct swap. Then put lap belts in and be done until you figure out the harness situation.
Mine came out of a mini van and tilts forward for storage behind it which is nice. I keep recovery gear back there.
I would just remove the old bench seat and start comparing brackets and see if it is a direct swap. Then put lap belts in and be done until you figure out the harness situation.
#8
#11
I'm putting bench seats in my 318i, and a ranger seat is a perfect fit.
-Garrick
Thread
Thread Starter
Forum
Replies
Last Post
rngprerunner
Interior, Exterior, & Electrical
19
07-09-2020 07:11 AM
firebirdude
Interior Semi-Tech
13
02-17-2016 01:43 AM