I know - wrong section, but i need help today cause i wanna get atleast the top half installed cause its such a nice day.
Of, its a flat roof, I got all the parts, however I got the cieling support box, its got 3 sides, according to the directions, your supposed to install it like this:
the yellow bucket is 'inside the shop' and the shiny piece is outside, however, if I install it in this fashion then the open end of the box is up, not down. In this configuration, the closed part / bottom of the box gives the 'finished' look on the inside.
I got a flange to go over the exterior piece - needs to be cut to size, but heres a ruff idea:
that flange peice would cover the gaping hole/end of the box, the open part...
i think I got this right, the directions arnt too clear, so is this right or no?
Also, what can I use as a seal where the funnel piece fits over the exterior pipe? just roofing cement?