General Ford Ranger Discussion General discussion of the Ford Ranger that does not fit in any other sub-forum.

2000 Ranger V6, jerking when accelerating after shifting

Thread Tools
 
Search this Thread
 
  #1  
Old 12-08-2014
watsont5's Avatar
Member
Thread Starter
Join Date: Apr 2013
Location: Battle Creek
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
2000 Ranger V6, jerking when accelerating after shifting

Hi guys, was looking for some suggestions on a problem I am having. Its a 2000 4x4 3.0 V6 with 175,000 on it.

When I shift gears and accelerate the truck jerks for a few seconds, it shifts fine so I dont think its the transmission, but it seems to be getting worse in the past week, and its seems to do it more when the truck is cold. Its doesn't do it all the time, but has been happing more and more, and I noticed I loose a little power when going up a hill, I hope its a spark plug or wire problem.

Thanks for any thoughts.
 
  #2  
Old 12-12-2014
iplayloudly's Avatar
Member
Join Date: May 2007
Location: Cordova, TN
Posts: 183
Likes: 0
Received 0 Likes on 0 Posts
similar thing happened to me recently... I was sure it was a tranny problem, but it turned out to be the motor hesitating right after certain shifts. The coil pack had a some rust where one of the wires plugged in. So take your plug wires off and check all the connections to make sure they are clean. I ended up replacing the pack and the plugs/wires too just for good measure. Problem solved.
 
  #3  
Old 12-18-2014
Pauljw's Avatar
Member
Join Date: Nov 2014
Location: Marengo, IN
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by iplayloudly
similar thing happened to me recently... I was sure it was a tranny problem, but it turned out to be the motor hesitating right after certain shifts. The coil pack had a some rust where one of the wires plugged in. So take your plug wires off and check all the connections to make sure they are clean. I ended up replacing the pack and the plugs/wires too just for good measure. Problem solved.
+1 on the above, my '03 was acting the same way just last month, replaced the coil pack and that solved the problem.

Paul
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
acleme1
2.9L & 3.0L V6 Tech
1
10-03-2008 06:32 AM
UnkeysMunkle
General Ford Ranger Discussion
6
02-13-2005 06:54 PM



Quick Reply: 2000 Ranger V6, jerking when accelerating after shifting



All times are GMT -6. The time now is 01:57 AM.