General Ford Ranger Discussion General discussion of the Ford Ranger that does not fit in any other sub-forum.
Sponsored by:
Sponsored by: DashLynx

?'s about 33's

Thread Tools
 
Search this Thread
 
  #1  
Old 07-27-2007
swamper06's Avatar
Member
Thread Starter
Join Date: May 2007
Location: McAdoo, PA
Posts: 735
Likes: 0
Received 0 Likes on 0 Posts
?'s about 33's

If i throw on a b/l and some 33's, and i don't get a tuner or recalibrate, will it mess up my tranny? My truck is an 06 4.0 at if that helps. Sorry i know this was covered somewhere but i couldn't find a straight answer.

Tim
 
  #2  
Old 07-27-2007
Silver's Avatar
Member
Join Date: Jun 2006
Location: edenton,nc
Posts: 2,708
Likes: 0
Received 0 Likes on 0 Posts
what gears you have

it will put a strain on the tranny but 33's are not too stress full
 
  #3  
Old 07-27-2007
swamper06's Avatar
Member
Thread Starter
Join Date: May 2007
Location: McAdoo, PA
Posts: 735
Likes: 0
Received 0 Likes on 0 Posts
4.10 gears. I know thats low enough but with the tranny being all electically controlled and the speedo being off will that mess up shifts and stuff?
 
  #4  
Old 07-27-2007
bryanjints's Avatar
Member
iTrader: (1)
Join Date: Dec 2005
Location: Mount Holly, NJ
Posts: 1,857
Likes: 0
Received 1 Like on 1 Post
Your truck will shift fine. 33's and 4.10's is a good combo.
 
  #5  
Old 07-27-2007
Silver's Avatar
Member
Join Date: Jun 2006
Location: edenton,nc
Posts: 2,708
Likes: 0
Received 0 Likes on 0 Posts
yep 33's and 4.10's is a good combo
but a good programmer,aka x-cal helps fix the speedo problem and shift points of your tranny

the thing about mods just one wont cut it its a combo of a few that make the real difference
mods=cash=hp and the butt dyno lol yada yada yada
 
  #6  
Old 07-28-2007
gatorblue92's Avatar
RF Veteran
Join Date: Jun 2004
Location: Delaware
Posts: 8,238
Likes: 0
Received 2 Likes on 2 Posts
you will be just fine... your speedo will be off by about 10 mph so at 70 you are really going 80
 




All times are GMT -6. The time now is 10:50 AM.