put in an ohc tonight everything went well until i put it back together. tested everything to make sure it worked and when i tested the 4x4 somehow it got stuck in 4x4 low and wont come out of it. question i have is the gray/black from the gem where does it get hooked up to in the ohc harness only wire i had left available was a red/black wire. also no temperture will come up on the display. i think i need help

 

gotta be in neutral with foot on the brake to get out of 4 low if you haven't done that already

go back through the how-to, check all your wires.

 

there was no colored wire that was gray/black on my ohc harness only a red/black wire that i had left would it matter if i connect these too to see what happens?