passenger door
#1
passenger door
does anybody else have a problem with having to slam their doors in order to get it to shut. i know this is a truck and i dont expect to be able to close like a door but i have to slam my passenger door pretty hard to get it to shut. a lot harder than the drivers side. does anybody else have this problem or a possible solution?
#4
You can adjust that out. I'd first loosen the latch assembly (3 screws), then tighten it just a little snug so it can move, test the door a few times, tighten. If that isn't enough adjustability, you'll need to adjust the pin on the frame.
I believe it is a T-55 driver for the door latch pin. Check its alignment with the door latch when the door is almost closed to see which way you need to adjust.
My PS was just the opposite, hard to open. Pin was scraping on the door latch bottom. I did have to adjust both to get it right. Wife's much happier.
I believe it is a T-55 driver for the door latch pin. Check its alignment with the door latch when the door is almost closed to see which way you need to adjust.
My PS was just the opposite, hard to open. Pin was scraping on the door latch bottom. I did have to adjust both to get it right. Wife's much happier.
#6
#7
#9
#12
Thread
Thread Starter
Forum
Replies
Last Post
goat_007
Exterior Semi-Tech
1
01-24-2012 02:07 PM
frontroyalva
OLD - Interior, Exterior, Electrical, & Misc.
0
04-11-2011 10:24 PM
studboy
OLD - Interior, Exterior, Electrical, & Misc.
0
07-26-2009 11:53 AM
yarrgh
OLD - Interior, Exterior, Electrical, & Misc.
1
05-31-2009 05:35 PM