customized my light bar a little
#1
customized my light bar a little
I was doing the wiring and decided that I didn't wanna see the wiring from underneath. So I covered it. I need a couple nuts to put on the lights studs to complete it but I think it looks killer.
I am gonna work on plugging the holes in the top to keep water from sitting in there but I think most of it will will drain out of the sides if any does get in. Anyway I thought some of you might benifit from this one. I know I am hardcore about keeping things clean looking and hidden.
Oh yeah, itz made from a piece of rubber similar to my gap guards but this is made like a base board trim that I just cut down to size with a razor knife.
I am gonna work on plugging the holes in the top to keep water from sitting in there but I think most of it will will drain out of the sides if any does get in. Anyway I thought some of you might benifit from this one. I know I am hardcore about keeping things clean looking and hidden.
Oh yeah, itz made from a piece of rubber similar to my gap guards but this is made like a base board trim that I just cut down to size with a razor knife.
#3
#6
Thread
Thread Starter
Forum
Replies
Last Post