Im BACK! and a suspension question
#1
Im BACK! and a suspension question
So I doubt most of you remember but we bought a 150 kept the ranger for my lil bro to drive..Well I had the hardest time parting with her even after having a 5.4l v8 under my foot vs my 3.0...soo I am back and starting to continue building my baby where I left off =D
Anyways here is the dilema.
Alright I have fiberglass on the front and pulled sides with 35's. I had fabtech spindles up front but sold them and now I have 35's on stock spindles. I know I have 15x8's but I am not super sure on the backspacing.
Anyways, my front rub pretty bad, but I do not want my front end sitting way up with lift spindles again. I am a full time student trying to find a job to save for my front end..have some ideas in mind, probably not LT as I do not need that. Probably some BTF uppers and 2.0's in the front..
my question is how can I get my front tires out about 2" a side without LT. Is running a different size backspacing just as bad as putting wheel spacers on? Are there any companies that fab a spindle at stock height that puts the wheel out about 2"s?
Thank you for any input. 03 Edge 3.0 stock suspension, blocks pulled in rear.
Any more info you need I can supply.
Thanks again.
Reference w/ spindles..probably how it is going to end up looking again.
Anyways here is the dilema.
Alright I have fiberglass on the front and pulled sides with 35's. I had fabtech spindles up front but sold them and now I have 35's on stock spindles. I know I have 15x8's but I am not super sure on the backspacing.
Anyways, my front rub pretty bad, but I do not want my front end sitting way up with lift spindles again. I am a full time student trying to find a job to save for my front end..have some ideas in mind, probably not LT as I do not need that. Probably some BTF uppers and 2.0's in the front..
my question is how can I get my front tires out about 2" a side without LT. Is running a different size backspacing just as bad as putting wheel spacers on? Are there any companies that fab a spindle at stock height that puts the wheel out about 2"s?
Thank you for any input. 03 Edge 3.0 stock suspension, blocks pulled in rear.
Any more info you need I can supply.
Thanks again.
Reference w/ spindles..probably how it is going to end up looking again.
Last edited by bmx4life; 11-30-2009 at 10:12 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Starlifter
SOHC - 2.3L & 2.5L Lima Engines
4
09-09-2014 04:12 AM
Want to Trade: 3" Suspension Lift for Stock Suspension - CA
safaripacific
OLD - Suspension, Tires, & Wheels
17
09-10-2012 07:08 PM
GenerationKill
Suspension Tech
9
11-28-2006 12:14 PM